Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • October 15, 2014 at 2:23 am #335857
    MICHAELWINN

    Hi there,

    I am trying to create a simple rollover on a basic page using:

    onmouseover=

    But the code will not load, is this an option? Any advice?

    This site is underdevelopment. So I would need to give you temp access to view.

    • This topic was modified 10 years, 2 months ago by MICHAELWINN.
    October 15, 2014 at 8:37 am #335996
    Devin

    Hi MICHAELWINN!

    Unless you need to target a specific function I would suggest not using onmouseover. Its a sidestep to your issue but any other alternative would be better.

    The automated schema output shouldn’t have any effect at all on this however. Does it work specifically it is turned on?

    Best regards,
    Devin

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.