Viewing 4 posts - 1 through 4 (of 4 total)
-
Posts
-
Where do I shorten the time between the time a layer comes in and leaves?
In this case I am trying to make the pig come in, barely pause and take off again. Not sure which settings to change though.
Thank you!
Hey Emma1202!
Under the “Transition” tab in the layer options it’s the “delay until” and “show until” settings.
Regards,
ElliottThank you!
So if I shorten the “show until” it should pause for a shorter amount of time, is that correct?
Viewing 4 posts - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.