Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • March 15, 2018 at 8:04 pm #927627
    frontastic-gmbh

    I created a post with diagonal section borders. Everything was fine. As I recently revisited the post, the diagonal borders are gone.
    In enfold backend section borders are still set to diagonal.
    Anyone an idea why they’re gone?

    March 15, 2018 at 11:54 pm #927802
    Vinay

    Hey frontastic-gmbh,

    I’m not sure why it is not working for you. Do you remember if any changes were made to the site or any plugins were recently added ? Please revert the recent changes and review the site.

    Make sure you have the latest version of the theme installed.

    Let us know if you still have an issue.

    Best regards,
    Vinay

    March 16, 2018 at 9:08 am #927980
    frontastic-gmbh

    Hi Vinay,

    I testet it first, of course. The problem exists since to last two releases of enfold.
    The only plugin change that I did recently was to buy and install “LayerSlider WP”. I deactivated it for test – but nothing changed.

    Thanks for you help
    Henning

    March 18, 2018 at 10:38 pm #928804
    Basilis

    Hi,

    I checked – which one of the section has it, because I can see every one disabled?

    Best regards,
    Basilis

    March 19, 2018 at 7:58 am #928900
    frontastic-gmbh

    Well, only the first hasn’t diagonal section, but e.g. the second and the third section has one. So the section “ATOMIC DESIGN EINFACH ERKLÄRT
    ” was with a diagonal boarder above and below.
    I added an ID “diagonal0” and “diagonal1” so that it could be fond easier.
    As I mentioned before: As I created the article, everything was fine…

    March 20, 2018 at 10:34 am #929673
    Vinay

    Hi,

    The login credentials provided is with limited access and we don’t have full admin right to check the issue.

    Please deactivate all plugins and check if the issue persists.

    Best regards,
    Vinay

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.