Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • July 15, 2015 at 6:17 pm #473907
    reidmccallhhi

    When I choose Boxed Layout from the Enfold settings, my slider doesn’t fill the “box”.
    I’ve tried all sorts of settings and changes and can’t seem to make it work.

    Any directions you have would be appreciated, thanks!

    Reid

    July 15, 2015 at 8:25 pm #473968
    Elliott

    Hey reidmccallhhi!

    The container will probably have some padding. Send us a link to your page and we’ll take a look.

    Regards,
    Elliott

    July 16, 2015 at 6:28 pm #474498
    reidmccallhhi

    I would like the site to remain at 1340 px wide at max, responsive below that.

    Thanks

    July 17, 2015 at 9:34 am #474746
    Rikard

    Hey!

    It looks to be filled on my end, or do you mean vertically? Please send a screenshot highlighting what you would like to change.

    Best regards,
    Rikard

    July 17, 2015 at 2:56 pm #474972
    reidmccallhhi

    Right now the Slider is cut off.
    I would like the site to be responsive but not stretch farther than 1250 px (width of my slider)
    I thought the best way to do this is Boxed mode with max pixel set, but that results in slider being cut off.

    What is the best way to accomplish this?

    July 17, 2015 at 6:27 pm #475112
    Dake

    Hey reidmccallhhi!

    If you reduce the global width to 1250px, does the slider also reduce in width?

    It appears to be a padding issue like Rikard suggested, but if the above solution doesn’t work.

    May we have temporary access to your website?

    Regards,
    Dake

    July 17, 2015 at 6:30 pm #475113
    reidmccallhhi

    yes see private

    July 19, 2015 at 2:58 pm #475387
    Ismael

    Hi!

    The container is set to 1010px because you forgot the “px” in the Maximum Container width field. It was set to “1240” so we changed it to “1240px”. Please remove browser cache then reload the page.

    Regards,
    Ismael

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.