Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • December 4, 2016 at 7:34 pm #720235
    data76

    Hi

    I need to display a button, once the viewer clicks on it, the layer transitions out, and within few seconds, auto loads the home site. Is this possible to do using the HTML section in layerslider? This is for use as an introduction page, and I’m not good at coding from scratch. Still learning.

    Thanks

    December 4, 2016 at 11:01 pm #720256
    Basilis

    Hey data76,

    Unfortunately it would require quite some time and customization of the theme to achieve this, so I am sorry to tell you that this is not covered by our support. However if its really important for you to get this done, you can always hire a freelancer to do the job for you :)

    Best regards,
    Basilis

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.